Article written by-Young Andreassen
You've done it. You're ready to handle your home's plumbing maintenance and repair. What perfect timing! You probably have tons of questions on how to start and what to do, but fear not, this article can help you. Listed below are some tips that will help you get started with your plumbing aspirations.
When choosing a plumber make sure he is insured and licensed. This is very important. If there is a plumbing emergency, you want to make sure the plumber has met the training requirements of the state. If
check out here is insured, this covers any accidental damage done while fixing your plumbing.
Avoid using any tablets that are meant to reduce odor in and around your toilet. These products will reduce the smell, but they will also cause problems with the rubber gaskets. Over time, the damage will accumulate and could eventually stop the toilet from functioning at all.
Get to know the tools and how they are used for the most success in plumbing. Read every manual, and use the Internet and library to research the projects that you plan on doing. Have a sound plan going into any do it yourself repair attempt, since mistakes will cost you dearly in money, time and stress.
If your toilet gets clogged, there is a low level of water in toilet, and the plunger is not working, you may fix the problem by dumping warm water from a bucket into your toilet from about waist level. The water should go down, and you can pour another bucket of water if the toilet is still clogged.
One way to prevent pipes from freezing during the winter is to keep cabinet doors in your house that contain the pipes open. This can insure that they get adequate heat to keep warm. Make sure also, to unhook and kind of hose outside and run a little water to clear the pipes of any remaining water going outside.
Check your toilet for any leaks. Try dropping a little food coloring in the tank. Then, observe the bowl. If the water turns the same color as the food coloring, you know there is some sort of leak that must be fixed right away.
Find out the plumbing codes in your local area before starting any project. Plumbing codes can vary wildly from area to area and you don't want to run afoul of the codes. Visit your local building department to find out information or hire a plumber for a day to help you go over your plans and provide advice.
Make sure to never leave any flammable liquids near your water heater. Certain liquids like gasoline, solvents, or adhesives are flammable, and if left too close to the water heater, can ignite. If you have to have these liquids in your basement, place it far away from your water heater.
Before embarking on a plumbing project, make sure that you're aware of where the shutoff valve for water in your home is, as well as the valves for shutting off individual structures like sinks, toilets, etc. This way, if something goes wrong, you'll be able to stop the water flow.
Believe it or not, it is not a very good idea to use a plunger if your toilet is clogged. Plungers just push whatever is stuck deeper into the drain. Instead, it is a better idea to use a closet auger. It will do a better job and is affordable.
To make sure your sump pump will run in an emergency, routinely test it by adding several buckets of water into the sump pit. The pump should turn on, remove the water and turn off with ease. Do this regularly, especially if your sump pump doesn't run that often, to ensure it will work when needed most.
Protect you plumbing pipes! If you live in an area which has cold winters and are leaving your home for an extended amount of time, protect your plumbing while you are gone! Shut off the main water valve! Drain the system of water by opening the faucets at the highest and lowest points of the house. Also, make sure that you have left some heat on in the house! Set the thermostat to at least 55 degrees Fahrenheit.
If attempting a plumbing repair yourself, be sure and have plenty of buckets on hand to catch spilling water. While you may have turned off the water supply, there is always some water left in the pipes and the larger the home and more extensive the plumbing system, the more water you may encounter.
If attempting a plumbing repair yourself, be sure and have plenty of buckets on hand to catch spilling water. While you may have turned off the water supply, there is always some water left in the pipes and the larger the home and more extensive the plumbing system, the more water you may encounter.
To check for toilet leaks, especially if it seems like your toilet is chronically running, use a few drops of food coloring in the toilet tank. If water is leaking into the bowl, you will see color in about a half hour. Replacing tank parts can repair leaks and greatly save on water consumption.
To help
best plumbing company save time and money, you should group all of your plumbing problems for one visit. Jot down all of your plumbing problems prior to calling the plumber. It saves both time and money if the plumber addresses all your problems in one visit.
To avoid plumbing disasters in your kitchen, never place hard-to-grind, stringy, fibrous waste, such as poultry skins, banana peels, carrots, celery, or cantaloupe pulp, into the garbage disposer. The disposer can't sufficiently grind these food products and they will clog your sink drain. You should also run cold water down the drain for about 15 seconds before and after using the garbage disposer to flush the waste down the main drain.
When attempting to diagnose a problem with the toilet, check out the flapper for roots of the problem. The plastic flapper and rubber stopper can deteriorate and cause the toilet to leak or run nonstop. Start by checking that your chain pressure is right, and if it is, you probably have to replace the flapper, since it could be worn.
You should feel better after reading those tips when it comes to plumbing. That was a lot to read through, but at least you should have an idea of what to do and where to begin with your home's plumbing. Besides, you can always come back to this list if you need to.